Installing a pitless adaptor

Also, be sure it is a sufficient diameter. Once "A", "B" and "C" have been removed, you will need to thread a portion of steel pipe into the top of the pitless elbow "F". Then lower it inside the well casing, carefully inserting the slide through the pre-cut hole. Make sure that the rubber washer, "D" is making direct contact with the inside of the well casing.

Next, you will need to install the outer rubber washer "C", brass washer "B" and the brass nut "A" from outside of the well casing.

You will need to hand tighten the nut ensuring the washer contour is aligned with the casing profile.

Then, tighten the brass nut using a wrench until it is tight and the gaskets are visibly compressed. It's important to ensure the pitless adapter remains upright by holding onto the pull pipe straight in the well casing. Remove the safety pin to allow removal of the elbow "F" portion of the pitless adapter out of the slide "E". At this point, you can attach the pipe column, which is the drop pipe and submersible pipe, and install the pump seating to the pitless elbow into the slide of the pitless adapter.

Make sure you firmly positioned it into the slide before disconnecting from the pull pipe. Once you have checked that it is firmly positioned, you can install the discharge pipe service line. Once it has been installed, ensure you check for leaks prior to back filling the trench. Making assumptions about how slide pitless adapters should be installed is unsafe and could lead to problems.

Be sure to keep these installation steps in your back pocket and refer to them to ensure a trouble free and accurate installation. Tags: Water Well , pitless adapter. Topics: Water Well , pitless adapter. At BoshartU, our goal is to equip you and your team with the knowledge you need to be more successful. We regularly publish new blogs and content that will help you become more comfortable and confident with our products. Subscribe to BoshartU Boshart. A spring-to-close check valve is required on the buried line between the Simple Pump pitless adaptor and the tee connecting into the buried line that runs between the well head and the pressure tank.

When the submersible is running, the water must be directed to the pressure tank rather than back-feeding the Simple Pump. The check valve prevents this from happening.

A spring-to-close check valve is also required on the buried line between the submersible pump pitless adaptor and the tee connecting into the buried line that runs between the well head and the pressure tank. When the Simple Pump is running, the water must be directed to the pressure tank rather than back-feeding the submersible pump. Please do not attempt this installation unless you are familiar with pitless adapters and how to properly install them. Inexperience can easily result in dropping components to the bottom of the well.

When installing the system, the work is best performed by two persons capable of handling perhaps 75 pounds each. Make sure you are very familiar with each step before you start it. If you are uncertain about any of these procedures, please call for help before you begin. You should be ready to pump water. It will require about 1 stroke for each foot of depth to bring the water up the first time. After that, it should deliver water within a few strokes, as long as there are no leaks.

It is recommended that you leave them outside of the pitless adapter disconnected until you confirm that you have water flow.

If the rider portion of the pitless lifts out of the saddle portion of the pitless the problem may be one of the following:.