Qlogic sansurfer for windows 2008

One of the most important storage network tuning parameters is data transfer size. It is critical that the data transfer size be the same or smaller than the storage controllers block size. Most storage network controllers have a default block size of 64KB or KB. In the first case the storage controller would receive the KB block in its buffer, then segment it into 8 64KB blocks, then write them to disk, in the second case, the storage controller would buffer the KB, then segment it into 4 KB blocks, then write them to disk.

The optimal setting is to match HBA driver block size to the size of the storage controllers block size. I have search a lot for this ,Queue depth is easily set on 10gig adaptor with any OEM but how to set same on 1 Gig Network adaptor. Office Office Exchange Server. Not an IT pro? Sign in. United States English. Ask a question. Quick access. Search related threads. Remove From My Forums. Asked by:. Archived Forums. Windows Server General Forum. Sign in to vote.

Qlogic model is QMH The maximum queue depth value, as was told by Microsoft port driver developer, is Qlogic sets the default value to Please note that the Microsoft storport. Please use the following procedure to change the qd parameter: 1. Enter a value upto 0xFE. The default value is 32 0x Click OK. Exit the Registry Editor, then shutdown and reboot the system.

Wednesday, February 22, PM. Wednesday, March 14, AM. Thank you Shani! Is execution Throttle and Queue depth both are same? Sunil Kumar Devangam. This number is needed for FC connectivity. The IEEE address is used when configuring your system. The serial number is used when communicating with Sun. All numbers are clearly marked on the board. Record these numbers before installation.

Remove the blank panel from an empty PCI Express slot. Optional Perform the following steps to replace the PCI bracket. Align the new mounting bracket tabs with the holes in the HBA. Replace the screws that attach the HBA to the bracket. Press firmly until the adapter is seated.

Replace the system case and tighten the case screws. The HBA is now installed in the system and is ready for the optical cable attachment. Use multimode fiber-optic cable, intended for short-wave lasers, that adheres to the specifications in TABLE 1. Connect the other end of the cable to the Fibre Channel device.

After the optical cable is connected to the HBA, you are ready to apply power to the system. Verify that the HBA is securely installed in the system. Verify that the correct optical cable is attached.

Each port has a corresponding set of yellow, green, and amber LEDs. Enter the show-devs command at the ok prompt to list the installed devices.

If online storage is connected to the HBA, use the apply show-children command to list the attached storage. During system power on initiation the following system booting BIOS initialization screen is displayed:.

The following QLogic Fast! UTIL menu is displayed. Then the following QLogic Fast! To exit the QLogic Fast! Install this patch cluster before installing the qlc driver patch. The following qlc driver patches are needed to support the HBA:. Use the patchadd command. SunSolve Online at:. Go to the QLogic download site for Sun Microsystems at:. Follow the instructions in the table to download the driver to a local drive.

After the driver is downloaded, download the appropriate utility program based on the type of system you are using to a local drive. Open the ReadMe and Release notes for the driver and utility, and follow the instructions for installing the driver and utility. To verify the installation, follow the instructions provided in the ReadMe file.

It supports the following functions:. Before you start this process, ensure that the operating system is installed and that your system is configured with the latest Service Pack and Windows Update. See Installing the HBA for more information. Power up the system and allow Windows OS to boot.